Crankshaft, Measuring Axial Clearance
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Dial Gauge Holder VW387
- Dial Gauge - 0-10mm VAS6079
Procedure
-- Install the Dial Gauge - 0-10mm VAS6079 with the Dial Gauge Holder VW387 on the cylinder block as shown in the illustration.
-- Place the dial gauge against the crankshaft counterweight.
-- Press the crankshaft against the dial gauge by hand and set the gauge to "0".
-- Press the crankshaft off the dial gauge and read the measurement.
- Axial play: 0.15 to 0.25 mm.