Overview - Balance Shaft
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Balance Shaft
- Removing and installing, refer to BALANCE SHAFT, REMOVING AND INSTALLING .
- Bolt
- Tightening specification: 60 Nm
- To loosen and fasten, use drill diameter 8 mm as counter-holder
- Balance Shaft Transmission Side
- Can only be placed on the balance shaft in one position
- Gear Carrier
- Bolt
- Tightening specification: 13 Nm
- Balance Shaft Belt Pulley Side
- Can only be placed on the balance shaft in one position
- Bolt
- Tightening specification: 60 Nm
- To loosen and fasten, use drill diameter 8 mm as counter-holder