Wheel Bearing Unit, Servicing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate VW401
Press Plate VW402
Press Piece - Multiple Use VW412
Hydraulic Press - Bushing Assembly Tool Kit T10230
Puller - Kukko Separating Tool - Diameter 25-155mm15/3 with
Puller - Kukko Quick Action Separating Tool - 25-155mm17/3

Wheel bearing housing is removed, refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .

Wheel Hub, Removing from Wheel Bearing

Fig 1: Pressing Wheel Hub Out Of Wheel Bearing

Courtesy of AUDI OF AMERICA, LLC

-- Install special tools as shown in illustration.

Press Piece - Multiple Use VW412
Sleeve T10230/3 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Thrust piece T10230/8 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Wheel bearing unit
Press Plate VW402
Press Plate VW401

-- Press the wheel hub out of the wheel bearing.

Fig 2: Bearing Inner Race And Spinning Washer

Courtesy of AUDI OF AMERICA, LLC

-- Insert the separating tool between the bearing inner race -1- and the wheel hub -2- and pretension with the spindle.

NOTE:

Use a commercially available separating tool such as the Kukko 15/3 with 17/3.

-- Install special tools as shown in illustration.

Fig 3: Pressing Bearing Inner Race From Hub

Courtesy of AUDI OF AMERICA, LLC

Press Piece - Multiple Use VW412
Sleeve T10230/8 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Thrust piece T10230/3 from the Hydraulic Press - Bushing Assembly Tool Kit T10230
Kukko 15/3 with 17/3

-- Press the bearing inner race from the hub.

Pressing wheel hub into wheel bearing

Fig 4: Pressing Wheel Hub Into Wheel Bearing

Courtesy of AUDI OF AMERICA, LLC

-- Install special tools as shown in illustration.

Press Piece - Multiple Use VW412
Press Plate VW402
Wheel hub
Ball Bearing
Press Plate VW401

NOTE:

The reworked surface on the wheel bearing outer race faces down.

CAUTION:

When setting down or pressing in, make sure there is no dirt or contaminants between the Press Plate VW401 -5- and the ball bearing -4-.

-- Press the wheel hub into the wheel bearing.

-- Install the wheel bearing unit, refer to WHEEL BEARING UNIT, REMOVING AND INSTALLING .