Front And Rear Upper Control Arm Bearing, Removing And Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Subframe Bushing Tool Kit 3301
- Bearing Installer - Multiple Use 3348
NOTE:
There is a bonded rubber bushing with a different rubber mixture installed in the top of the control arm. Installing more than one kind is not permitted. Allocation, refer to parts.
NOTE:
Control arms must only be clamped in a vise with protective vise jaw lining!
A = ~ 90° ± 5°
A = bearing
NOTE:
Do not use lubricant!