Electronic Damping Control Module -J250-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Electronic Damping Control Module

Courtesy of AUDI OF AMERICA, LLC

The Electronic Damping Control Module -J250- is located behind the right luggage compartment side trim panel.

-- Turn off all electrical consumers.

-- Remove the key.

-- Remove the cover from the right luggage compartment storage compartment.

-- If installed, unclip the Towing Recognition Control Module -J345- -1- from the control module bracket -2-.

-- Remove the nuts -arrows-, pull the control module bracket -2- off the threaded pins and move it downward.

-- Release the clips -A- and -B- and remove the Electronic Damping Control Module -J250- -1- from the control module bracket -2-.

Fig 2: Open Clamps And Remove Electronic Damping Control Module From The Control Module Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector -3- and remove it from the Electronic Damping Control Module -J250- -1-.

-- Remove the Electronic Damping Control Module -J250- -1-.