Tires, Mounting
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.
- Make sure wheel rim is clean.
-- After using tire sealing liquid, wheel electronics must be replaced, since there is the possibility of incorrect measurements due to liquid deposits on pressure sensor.
-- Insert a new tire valve.
-- Remove the valve insert.
-- Inflate tire to approximately 3 to 4 bar (43.5 to 58 psi), tire bead must audibly slide over rim hump.
-- Install valve insert.
-- Correct inflation pressure to the specified pressure.
-- Balance wheel.