Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

The Tire Pressure Monitoring Control Module -J502- is located in the right front footwell under the instrument panel.

Before removing the Tire Pressure Monitoring Control Module -J502-, perform Guided Fault Finding under "Replace Control Module ".

-- Remove the glove compartment, refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove the sill panel strip, refer to SILL PANEL STRIP, REMOVING AND INSTALLING, FRONT SILL PANEL .

CAUTION:

Make sure the carpet does not tear when handling it.

-- Carefully lay the carpet aside with the help of a second technician.

-- Move the insulating mat -arrow- up.

Fig 1: Moving Insulating Mat

Courtesy of AUDI OF AMERICA, LLC

-- Disengage and disconnect connector -3-.

Fig 2: Release And Remove Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -1- and remove the Tire Pressure Monitoring Control Module -J502- -1- upward.