LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 635 (Wheels, Tires & Wheel Alignment) >> 44 Wheels, Tires, Wheel Alignment >> Lane Assist >> Directional Stabilization Assistance Control Module -J759- And Lens, Removing And Installing >> Installing

Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using a Cleaning Solution.

After installing the Directional Stabilization Assistance Control Module -J759-, make sure it fits correctly in its bracket.

If the Directional Stabilization Assistance Control Module -J759- is replaced, the camera and the Directional Stabilization Assistance Control Module -J759- must be calibrated, refer to CALIBRATION PROCEDURE .