Installing

Install in reverse order of removal. Note the following:

Studs in bracket are preset. If necessary, correct adjustment.

-- Place the Adaptive Cruise Control Sensor -G550- on a soft, clean cloth.

Fig 1: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- must be 43 mm.

-- Insert bracket and tighten bolts.

NOTE:

While installing the bracket for the Adaptive Cruise Control Sensor -G550-, position it facing the center of the vehicle (as shown) and then tighten it.

Fig 2: Installing Bracket For Adaptive Cruise Control Sensor Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Follow the tightening sequence:

Fig 3: Installing Bracket For Adaptive Cruise Control Sensor Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the screw -1- in the oblong hole, then install the screw -2- in the hole and tighten it. Tighten the screw -1- in the oblong hole.

-- Install the Adaptive Cruise Control Sensor -G550- and carefully push three nuts by hand onto the stud bolts in the sensor.

-- Install the air intake grille, refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING, AUDI Q5 .

-- Calibrate the adaptive cruise control, refer to ADJUSTMENT PROCEDURE USING Setting Device Basic Set VAS6430/1 .