Steering Column Electronics Control Module -J527-, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Feeler Gauge
The Airbag Spiral Spring/Return Spring with Slip Ring -J527- and the Steering Angle Sensor -F138- are integrated in the Steering Column Electronics Control Module -G85-.
-- If replacing the control module, select the "Replace Control Module " function using the Vehicle Diagnostic Tester.
CAUTION:
Risk of damaging coil connector.
- Steering must be in center position (wheels in straight ahead position) when removing and installing coil connector with slip ring.
- Return spring with slip ring is not to be turned following removal.
WARNING:
Danger Of Unintended Engine Ignition
Turn off the ignition and remove the ignition key from the vehicle interior for all work performed on the high voltage vehicle.