Access/Start Authorization Switch -E415-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification, refer to Figure.

Install In Reverse Order Of Removal. Note The Following:

-- Install the center instrument vent, refer to INSTRUMENT PANEL VENTS AND REAR VENTS, REMOVING AND INSTALLING .

-- On USA vehicles, install the right impact absorber, refer to BUMPER, REMOVING AND INSTALLING .

-- Install the driver side instrument panel cover, refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

Connector Assignment For Access/Start Authorization Switch -E415-

Fig 1: Identifying Authorization Switch Connector

Courtesy of AUDI OF AMERICA, LLC

3 - Not Assigned

4 - Not Assigned

5 - S-contact

6 - Terminal 15

7 - LIN

8 - Terminal 30

9 - Not Assigned

10 - Not Assigned

11 - Not Assigned

12 - Not Assigned

13 - RED2, terminal 15

14 - RED, terminal 15

15 - Ignition/starter switch +

16 - Terminal 31