Left/Right Hid Headlamp Control Module -J343- /J344, Removing And Installing, Through My 2012: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Danger To Life Due To High Voltage.

When working on the components marked with yellow high-voltage symbols the HID headlamp must be de-energized.
Turn off the ignition and all electrical consumers and remove the ignition key.
Do not touch the flasher.

-- Turn the light switch to position "0".

-- Turn off the ignition and all electrical consumers and remove the ignition key.

-- Do not touch the flasher.

-- On the right: remove the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the bolts -arrows-.

Fig 1: Identifying HID Headlamp Control Module Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the control module -4- from headlamp housing.

-- Disconnect the adapter wire -3- and connector -1- on the HID headlamp control module.

-- Remove the HID headlamp control module.