Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Note the following before removing the steering column:
Create a sketch showing the:
- routing of the electrical wiring harnesses
- securing of the electrical wiring harnesses
- cable tie locations.
This especially applies to the wiring harness to the Electronic Steering Column Lock Control Module -J764-.
Note the following before installing the steering column:
- Route the electrical wiring harnesses exactly the way they were before removal.
- Secure the electrical wiring harnesses exactly the way they were before removal.
- Install all the cable ties that were loosened or cut in the same locations when installing the steering column.
- Make sure the wiring harness to the Electronic Steering Column Lock Control Module -J764- is not pinched and does not come into contact with sharp edges when adjusting the steering column.
Only the following steering column components need to be removed to replace the Electronic Steering Column Lock Control Module -J764- :
- Driver side airbag, refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING ,
- Steering wheel, refer to AIRBAG STEERING WHEEL, REMOVING AND INSTALLING .
- Steering column trim panel, refer to OVERVIEW - STEERING COLUMN TRIM PANEL ,
- the required electrical wires and connectors
-- Remove the steering column, refer to STEERING COLUMN, REMOVING AND INSTALLING .
-- Remove the bolt -1- and the Electronic Steering Column Lock Control Module -J764- -2-.
WARNING:
- After removing the control module, make sure no dirt or foreign objects enter the steering column.