Active Steering Safety Lock Actuator, Removing And Installing, Dynamic Steering: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When the active steering safety lock actuator is removed, do not turn the steering wheel or change the straight position or angle of the front wheels. Otherwise the position of the steering wheel may be incorrect after the work is completed. Follow all the rule for cleanliness when performing the following work.

-- Turn the steering wheel into the straight-ahead position (the wheels on the front and rear axle must now line up) and lock the steering wheel lock in the straight-ahead position.

-- Turn off the ignition and remove the key.

-- Mark the installed position and the position of the active steering safety lock actuator (dynamic steering) -arrow- (needed for installation later).

Fig 1: Identifying Position Of Active Steering (Dynamic Steering) Safety Lock Actuator

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -4- from the active steering safety lock actuator (dynamic steering) -3-.

-- Remove any paint still on the bolt heads -1 and 2-.

-- Remove the bolts -1 and 2- and remove the active steering safety lock actuator (dynamic steering) -3- from the steering column.

Use the socket provided in the repair kit for the new active steering safety lock actuator (dynamic steering) to remove the bolts -1 and 2-.