Active Steering Safety Lock Actuator, Removing And Installing, Dynamic Steering: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- After replacing the active steering safety lock actuator (dynamic steering), update the software for the Active Steering Control Module -J792- by starting the appropriate program on the Vehicle Diagnostic Tester.
- If a new active steering safety lock actuator (dynamic steering) is installed, transfer the marking from the old one to the new one.
-- Position the new active steering safety lock actuator F (dynamic steering) as marked before removal and secure it as listed in the following table using the two new bolts -1 and 2- (use the socket provided in the repair kit).
| Sequence | Screw number | Tightening specification |
|---|---|---|
| 1 | 1 | 2 + 2 Nm |
| 2 | 2 | 4 + 2 Nm |
| 3 | 1 | 8 + 2 Nm |
| 4 | 2 | 8 + 2 Nm |
-- Connect the connector on the active steering safety lock actuator (dynamic steering).
-- Erase the DTC memory.
-- Perform an initializing drive - turn the vehicle 45° to the left/right from the straight-ahead position.
Function Test
Check the function of the steering during the road test and a fenced off area.
- Operating force
- Reset
- Play
- Noise
- Indicator lamp
- Read the DTC memory after the road test. There must be no faults in the DTC memory.