Hydraulic Oil Cooler, Vehicles With Dynamic Steering, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front lock carrier cover, refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Clamp off the hydraulic lines -5- and -6- using the Hose Clamps Up To 25 mm Diameter3094.

Fig 1: Hydraulic Oil Cooler, Vehicles With Dynamic Steering (1 Of 2)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clamping sleeves -3- and -4-.

Fig 2: Hydraulic Oil Cooler, Vehicles With Dynamic Steering (1 Of 2)

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the hydraulic lines -5- and -6- from the hydraulic oil cooler.

-- Release the retaining tabs -3-, tilt the hydraulic oil cooler -1- forward slightly and remove it from the mounts -2- on the A/C condenser.

Fig 3: Hydraulic Oil Cooler To Condenser

Courtesy of AUDI OF AMERICA, LLC