Hydraulic Oil Cooler, Vehicles With Dynamic Steering, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

The connections must free of oil and grease, clean if necessary.

-- The markings -2- on the hose line must point upward in the >>12 o'clock<< position, refer to Fig 2.

Fig 1: Locating Hose Line Markings

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

When attaching the hose lines -1-, counter-hold on the pipe lines -4-.

-- Fill the Hydraulic Fluid.

-- Clean any oiled places.

-- Bleed the steering, refer to STEERING, BLEEDING AFTER REPLACING .

-- Check power steering fluid level, refer to OIL LEVEL AND STEERING HYDRAULICS, CHECKING LEVEL, BLEEDING AND CHECKING FOR LEAKS .

-- Check all open line connections for leaks, refer to STEERING, CHECKING FOR LEAKS .

-- Install the front lock carrier cover, refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

Installation Position Of Clamp

Fig 2: Identifying Clamp Installation Position

Courtesy of AUDI OF AMERICA, LLC

-- Close the clamp completely using the Hose Clip Pliers VAG1275A.

Do not exceed dimension -A- by 1 mm. If necessary, tighten the clamp with Hose Clip Pliers VAG1275A.

NOTE:

Secure all hose connections with hose clamps appropriate to the model, refer to parts.