Tie Rod End, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Tie Rod Head / Tie Rod Dimension

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front wheel .

-- Measure the dimension -a- between the tie rod head -1- and the left and right tie rod -2- and make a note of the value. Dimension -a- must be the same on the left and right sides after installing.

-- If necessary, shorten the "longer" tie rod head (installed it deeper into the tie rod).

-- Remove the nut -1- from the tie rod end joint pin -2- until it is flush with the joint pin threads. Counterhold when loosening.

Fig 2: Identifying Tie Rod End Joint Pin

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To protect thread, screw nut on pin a few turns.

-- Remove the tie rod end from the wheel bearing housing using the Puller - Ball Joint T40010A. Remove the nut.

Fig 3: Removing Tie Rod Ball Joint

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure that both puller lever arms are parallel to each other when using greatest force, adjust if necessary.

-- Loosen the nut -2-. Counterhold the tie rod end -3-.

Fig 4: Identifying Tie Rod End & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tie rod end -3-.