Overview - Electromechanical Power Steering Gear With Tie Rods
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Electromechanical Steering Gear with Tie Rods
- with Power Steering Control Module -J500-
- Removing and installing, refer to ELECTROMECHANICAL POWER STEERING GEAR, REMOVING AND INSTALLING .
- Servicing, refer to OVERVIEW - ELECTROMECHANICAL POWER STEERING GEAR .
- There are different versions, refer to parts.
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and installing on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.
- Bolt
- 80 Nm +180°
- Always replace if removed
- Subframe
- Nut
- Pushed into the subframe
- Always replace if removed
- Steering Intermediate Shaft
- Bolt
- Tightening specification: 30 Nm +90°
- Always replace if removed
- The threaded hole for the bolt must always be cleaned, for example, with a thread cutter
- See Figure -item 4-
- Wheel Bearing Housing
- Nut
- 100 Nm
- Always replace if removed