Vacuum Pump, Removing And Installing, 3.0L TDI Engine: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Covers, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover carefully from the retaining pins, one after another.

-- Remove the right diagonal tower brace.

-- Loosens the hose clamp on the vacuum hose.

-- Remove the vacuum hose -1- from the pump -3-.

Fig 2: Vacuum Hose -1- And Vacuum Pump -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not remove the vacuum hose on the plenum chamber bulkhead -2-.

CAUTION:

Do not damage the vacuum hose. Replace the vacuum hose if damaged.

-- Remove all the bolts -arrows- on the vacuum pump sealing flange.

Fig 3: Vacuum Pump Sealing Flange Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum pump from the mount.