VACUUM PUMP, REMOVING AND INSTALLING, 2.0L TFSI Engine: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the seals.

Make sure the seals are correctly installed.

-- Position the vacuum pump tappet so it engages in the groove on the camshaft when vacuum pump is installed.

-- Install and tighten all the bolts -arrows- on the vacuum pump sealing flange, refer to -item 1- Torx 30 Bolt (Quantity: 2).

Fig 1: Identifying Vacuum Pump Bolts Location

Courtesy of AUDI OF AMERICA, LLC

-- Push the new hose clamps over the vacuum hose.

-- Push the vacuum hose over the connection to the vacuum pump.

-- Compress the hose clamp on the vacuum pump connections with pliers.

CAUTION:

Do not damage the vacuum hose. Replace the vacuum hose if damaged.

-- Install the high pressure fuel pump, refer to HIGH PRESSURE PUMP, REMOVING AND INSTALLING .

-- Install the fuel line bracket on the vacuum pump and fuel high pressure pump.

-- Connect the small vacuum hose to the fuel line.

-- Connect the fuel high pressure pump connector -1-.

-- Install the engine cover.