High Pressure Pump, Removing And Installing, 2.0 L TDI Engine: Removing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Covers

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover.

-- Remove the diesel particulate filter pressure sensor -1- on the bracket.

Fig 2: Identifying Diesel Particulate Filter Pressure Sensor -1-, Pressure Sensor -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the wire -2- from the pressure sensor and carefully move it to the side.

-- Remove the double clip from the bracket.

-- Remove the pressure sensor bracket on the vacuum pump, 2 nuts.

NOTE:

There are two additional nuts under the pressure sensor bracket, which also must be removed.

-- Remove the coolant pipe from the vacuum pump stud and move it to the side.

-- Remove the vacuum hose form the vacuum pump.

-- Remove all the bolts on the vacuum pump sealing flange.

-- Remove the vacuum pump from the mount.