Electric Vacuum Pump, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specifications, refer to OVERVIEW - ELECTRIC VACUUM PUMP .
-- Insert the Brake System Vacuum Pump -V192- -1- into the bracket.
NOTE:
Make sure the vacuum pump fits correctly in the bracket. The vacuum connection faces the direction of travel.
-- Tighten the Brake System Vacuum Pump -V192- and the nuts -arrow- on the mount.
-- Slide the vacuum hose -2- onto the vacuum connection far enough so that it audibly engages.
CAUTION:
Be careful not to damage the vacuum hose. Replace the vacuum hose if damaged.
-- Insert the connector -1- into the clip on the Brake System Vacuum Pump - V192- mount.