Overview - Front Brakes, 1LA, 1LJ, 1ZB And 1ZT
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The single-piston brake 1LA/1LJ/1ZB/1ZT is illustrated.
When servicing, always install entire repair kit.
- Bolt
- Tightening specification: 30 Nm
- Protective Cap
- Insert in brake caliper
- Refer to CAP AND GUIDE PIN, REPLACING
- Guide Pin
- Slide through the boot
- Refer to CAP AND GUIDE PIN, REPLACING
- Protective Cap
- Install on the bleeder valve.
- Bleeder Valve
- Tightening specification: 15 Nm
- Before installing, lightly lubricate thread with assembly paste .
- Brake Caliper
- Spring
- Ensure installation position is correct.
- Protective Cap
- Do not damage when installing piston
- Coat with a thin layer of lithium grease .
- Piston
- Coat with a thin layer of lithium grease .
- Seal
- Coat with a thin layer of lithium grease
- Brake Carrier
- Removing and installing
- The four retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- Bolt
- Tightening specification: 196 Nm