Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Press the button on the parking brake to activate it.

-- Move the selector lever into "S".

-- Carefully pry out the selector lever boot on the side in direction of -arrows- using the Trim Removal Wedge 3409 or a small screwdriver and then fold it upward.

Fig 1: Identifying Selector Lever Boot

Courtesy of AUDI OF AMERICA, LLC

-- Release the spring -2- and remove the Selector Lever Transmission Range Position Display Unit -Y26- -1- -arrow-.

-- Disconnect the connector.

Fig 2: Releasing Retaining Spring And Removing Selector Lever Transmission Range (TR) Position Display Y26 Upward

Courtesy of AUDI OF AMERICA, LLC