Selector Lever Boot, Removing From Selector Lever Handle: Removing
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the selector lever handle, refer to SELECTOR LEVER HANDLE, REMOVING AND INSTALLING .
-- Bind the selector lever handle spring tabs -A- together with cable ties -B-, as shown in the illustration.
-- Slide the selector lever boot sleeve -C- over the tabs on the spring tab in direction of -arrow-.
-- Remove the cable ties and the selector lever boot and sleeve from the selector lever.