Automatic Transmission Fluid Lines, Cleaning

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit SMN372500
Hose diameter approximately 18 mm
Compressed air gun, commercially available
Protective eyewear

Procedure

NOTE:

Clean working conditions for the automatic transmission, refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Before installing a replacement transmission, always clean out the ATF cooler and ATF pipes using compressed air (maximum 10 bar (145 psi)).

NOTE:

If extremely dirty ATF flows out when cleaning using compressed air, flush the ATF cooler and lines using clean ATF.