3. Check the Closing Locks - Vehicles without an Ignition Key Lock
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
-- Press the Access/Start Authorization Button -E408- briefly to get "ignition on".
-- Do not move the selector lever into "P" but rather, for example, into "N".
-- Turn off the ignition.
- A warning message must appear in the instrument cluster.
- The vehicle cannot be locked.
-- Turn on the ignition, shift the selector lever into the "P" position.
-- Turn off the ignition.
- The vehicle can be locked.
If the specified values are not obtained:
-- Perform Guided Fault Finding using the Vehicle Diagnostic Tester.
-- Adjust the selector lever cable, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
-- Locking button on selector lever handle, checking, refer to 4. CHECK LOCKING BUTTON IN THE SELECTOR LEVER HANDLE .