LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 629 (Controls & Housing - Automatic Transmission 0BK) >> 37 Controls, Housing >> ATF Circuit >> Overview - ATF Circuit >> Vehicles with a 3.0L TDI Biturbo Engine

Vehicles with a 3.0L TDI Biturbo Engine

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: ATF Cooler, Radiator And ATF Lines Overview (Vehicles with a 3.0L TDI Biturbo Engine)
GWWA37-10912Courtesy of AUDI OF AMERICA, LLC
  1. Clip
  2. O-Ring
    • Replacing
    • Coat with ATF before installing
  3. ATF Cooler
  4. Bolt
    • Tightening specification: 8 Nm
  5. O-Ring
    • Replacing
    • Coat with ATF before installing
  6. Clip
  7. O-Ring
    • Replacing
    • Coat with ATF before installing
  8. ATF Pipe
  9. Bolt
    • Tightening specification: 20 Nm
    • First insert the ATF pipes with new O-rings by hand as far as the stop
    • The retaining tab on the lower ATF pipe must lie on the transmission threads
    • The retaining tab on the upper ATF pipe must touch the lower one.
  10. Bolt
    • Tightening specification: 8 Nm
  11. O-Ring
    • Replacing
    • Coat with ATF before installing
  12. ATF Pipe
  13. Bolt
    • Tightening specification: 8 Nm
scientia non olet · About LEMON Manuals