LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 629 (Controls & Housing - Automatic Transmission 0BK) >> 37 Controls, Housing >> ATF Circuit >> Overview - ATF Circuit >> Vehicles with a 2.0L TFSI Engine

Vehicles with a 2.0L TFSI Engine

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Radiator And ATF Pipes Overview (Vehicles with a 2.0L TFSI Engine)
GWWA37-11148Courtesy of AUDI OF AMERICA, LLC
  1. ATF Cooler
  2. Bolt
    • Tightening specification: 9 Nm
    • For attaching the ATF pipe to the engine
  3. ATF Pipe, Return
    • From the ATF cooler to the transmission
    • Before removal, mark the ATF pipes in relation to each other so they are not switched.
  4. O-Ring
    • Replacing
    • Coat with ATF before installing
  5. O-Ring
    • Replacing
    • Coat with ATF before installing
  6. Bolt
    • Tightening specification: 5 Nm
    • First insert the ATF pipes with new O-rings by hand as far as the stop
  7. ATF Pipe, Supply
    • From the transmission to the ATF cooler
    • Before removal, mark the ATF pipes in relation to each other so they are not switched.
  8. Bolt
    • Tightening specification: 5 Nm
    • First insert the ATF pipes with new O-rings by hand as far as the stop
  9. Nut on the ATF Pipe
    • Tightening specification: 29 Nm
    • The ATF pipes are secured to each other
  10. ATF Pipe, Supply
    • From the transmission to the ATF cooler
    • Before removal, mark the ATF pipes in relation to each other so they are not switched.
  11. O-Ring
    • Replacing
    • Coat with ATF before installing
  12. O-Ring
    • Replacing
    • Coat with ATF before installing
  13. Bolt
    • 20 Nm
    • first insert the ATF pipes with new O-rings by hand as far as the stop
    • The retaining tab on the lower ATF pipe must lie on the transmission threads
    • The retaining tab on the upper ATF pipe must lie on the lower one.
  14. Bolt
    • Tightening specification: 9 Nm
    • For attaching the ATF pipe to the engine
  15. ATF Pipe, Return
    • From the ATF cooler to the transmission
    • Before removal, mark the ATF pipes in relation to each other so they are not switched.
scientia non olet · About LEMON Manuals