ATF Pipes, Removing And Installing, Vehicles With 2.0L TFSI Engine: Removing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulations -1 and 2-, refer to OVERVIEW - NOISE INSULATION .

-- Place the Used Oil Collection and Extraction Unit VAG1782 under the corresponding separating points on the ATF pipes.

Fig 2: Identifying ATF Return & Supply Pipe

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Before removal, mark the ATF pipes in relation to each other so they are not switched.

-- Disconnect the ATF return pipe -1- and the ATF supply pipe -2-.

-- Remove the bolts -arrows- from the ATF pipes on the engine.

NOTE:

Place the Used Oil Collection and Extraction Unit VAG1782 or a catch tray under the transmission to catch any leaking ATF.

Fig 3: Identifying ATF Pipe

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clip -A- holding the Mechatronic wiring harness from the ATF pipe -B-.

-- Remove the bolt -arrow-. Then pull the ATF pipes -B and C- off the transmission and tie them up.

-- Seal the open lines and connections with clean plugs from the Engine Bung Set VAS6122.

-- Remove the ATF pipes.