ATF Cooler, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Power Steering Hydraulic Line

Courtesy of AUDI OF AMERICA, LLC

-- Remove the subframe crossbrace, refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .

CAUTION:

The suspension components could be damaged.

Do not rest the vehicle on its wheels if the subframe mount, the steering gear or the subframe crossbrace are not installed correctly.

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

Fig 2: Identifying ATF Cooler & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clamps -1 and 4- and disconnect the ATF pipes.

NOTE:

Place a clean cloth under the separating point to catch the escaping coolant.

-- Loosen clamps -2 and 3-, then seal off and remove the coolant hoses Hose Clamps - Up To 25mm 3094.

-- Remove the bolts -arrows- and remove the ATF cooler.