Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

GWWA10-11100

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front noise insulation -1-, refer to OVERVIEW - NOISE INSULATION .

-- Remove the connector -3- on the Secondary Air Injection Pump Motor -V101- from the bracket and disconnect.

Fig 2: Component Location Of Secondary Air Injection (AIR) Pump Motor -V101-

GWWA26-10531

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the hoses -1- and -2- for the secondary air injection (AIR).

NOTE:

The installation location is shown with the wheel housing lining removed.

-- Audi Q5: Remove the right air intake grille, refer to BUMPER COVER, REMOVING AND INSTALLING .

Fig 3: Identifying Air Intake Grille

GWWA63-10338

Courtesy of AUDI OF AMERICA, LLC

-- Audi Q5 S line/SQ%: remove the bumper cover end plate, refer to BUMPER COVER, REMOVING AND INSTALLING .

Fig 4: Identifying Bolts & Front Bumper Cover End Plate

GWWA63-10234

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The installation location is shown with the bumper cover removed.

-- Remove the nuts -arrows- and the Secondary Air Injection Pump Motor -V101-.

Fig 5: Secondary Air Injection Pump Motor -V101- And Bolts

GWWA26-11342

Courtesy of AUDI OF AMERICA, LLC