Right Exhaust Manifold, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and self-locking nuts.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts, refer to Figure.

Fig 1: Exhaust Manifold Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the right engine mount, refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the right catalytic converter, refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the Heated Oxygen Sensor -G39-, refer to HEATED OXYGEN SENSOR - G39 - / OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER - G130 -, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .

-- Install the noise insulations, refer to OVERVIEW - NOISE INSULATION .