LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 627 (3.0L - Exhaust System & Emission Controls - Engine Code(S): CTUC & CTUD) >> 26 Exhaust System, Emission Controls >> Exhaust Manifold >> Exhaust Manifold, Removing And Installing >> Left Exhaust Manifold, Removing And Installing >> Installing

Left Exhaust Manifold, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal and self-locking nuts.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts, refer to Figure.

-- Install the engine supports with the left engine mount, refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the Heated Oxygen Sensor 2 -G108-, refer to HEATED OXYGEN SENSOR 2 - G108 - / OXYGEN SENSOR 2 AFTER CATALYTIC CONVERTER - G131 -, REMOVING AND INSTALLING .

-- Install the left catalytic converter, refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals