LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 627 (3.0L - Exhaust System & Emission Controls - Engine Code(S): CTUC & CTUD) >> 26 Exhaust System, Emission Controls >> Emissions Control >> Exhaust Door Control Units - J883 - / -J945-, Removing And Installing >> Removing

Exhaust Door Control Units - J883 - / -J945-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Bumper Cover -1- And Bolts
GWWA26-11383Courtesy of AUDI OF AMERICA, LLC
NOTE:

The installation and the removal for the left exhaust door control unit is described.

-- Remove the bolts -arrows- and pull the rear bumper cover -1- slightly downward.

-- Disconnect the connector -4-.

-- Lower the exhaust system rear section -1-.

-- Tighten the nuts -3- and remove the exhaust door control unit -2-.

Fig 2: Removing/Installing Exhaust Door Control Unit
GWWA26-11320Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals