Right Catalytic Converter, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Oxygen Sensors - Cylinder Bank 1 (Right)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Oxygen Sensor after Three Way Catalytic Converter -G130- -2-, refer to HEATED OXYGEN SENSOR - G39 - / OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER - G130 -, REMOVING AND INSTALLING .

-- Remove the right front muffler, refer to FRONT MUFFLER, REMOVING AND INSTALLING .

NOTE:

Ignore item -1-.

-- Remove the bolt -2-, press the retaining tab off the transmission and tilt it back in direction of -arrow-.

Fig 2: Identifying Bolt -2-, Press Retaining Tab Off Transmission & Tilt It Back -Arrow-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

-- Remove the nuts -arrows- and the right catalytic converter upward.

Fig 3: Identifying Nuts, Bolts And Right Catalytic Converter

Courtesy of AUDI OF AMERICA, LLC