Right Engine Mount, Removing And Installing: Removing

Fig 1: Mount 10 - 222 A With T40093/6 On Left And Right Suspension Strut Towers, As Illustrated

Courtesy of AUDI OF AMERICA, LLC

-- Install the Engine Support Bridge 10-222A with the Engine Support - Supplement Kit Adapter 6 T40093/6 on the left and right suspension strut tower, as shown in the illustration.

-- Engage the Engine Support Bridge - Spindle10-222A/11 in the left and right engine lifting eyes.

-- Lightly pretension engine with spindles.

-- Remove the right front wheel.

Fig 2: Identifying Front Wheel Housing Liner

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right front wheel housing liner -1-, refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Remove the noise insulation -1- and -2-, refer to OVERVIEW - NOISE INSULATION .

Fig 3: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove and disconnect the connector -2- on the Right Electrohydraulic Engine Mount Solenoid Valve -N145-.

Fig 4: Locating Nut On Electrical Wiring Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- and remove the bracket with the wiring harness from the subframe.

-- Remove the bolts -1, 2 and 4- and move the right engine mount retaining plate -3- to the side.

Fig 5: Identifying Bolts And Right Engine Mount Retaining Plate

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolt -arrow- on ATF line bracket.

Fig 6: Identifying ATF Line Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Lift the engine using the right Engine Support Bridge - Spindle10-222A/11 item -1- to dimension -a-.

• Dimension -a- = approximately 20 mm.

-- Remove the right engine mount.

Fig 7: Identifying Special Tool - 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC