Engine, Securing On Engine And Transmission Holder

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Sling 2024A
Engine And Transmission Holder VAS6095 with Engine/Transmission Holder - Universal Mounting VAS6095/1 and Engine/Transmission Holder - V6 FSI Bracket VAS6095/1-5
Shop Crane VAS6100
Lift Arm Extension VAS6101

Procedure

WARNING:

There is the risk of an accident.

The engine may be transported only in the manner described and without the transmission.

The engine/transmission subassembly is removed and the engine and transmission are separated.
Engine secured with Articulated Joint Support VAS6131/13-7.

-- Engage the Engine Sling 2024A on the engine lifting eyes and on the shop crane as shown in the illustration.

Fig 1: Identifying 2024 A, Installation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the illustration.

WARNING:

There is the risk of an accident.

Lifting hooks and alignment pins on the engine sling must be secured with locating pins -arrows-.

-- Tension engine slightly with shop crane, do not raise.

NOTE:

The illustration shows the installation position with the engine installed.

-- Remove the left and right connector -arrow- from the mount, disconnect it, and free up the wire.

-- Remove engine bracket left and right bolt -1-.

-- Remove the nut -2- and free up the electrical wiring bracket.

Fig 2: Disconnect Left Electrohydraulic Engine Mount Solenoid Valve

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Articulated Joint Support VAS6131/13-7 from the engine.

Fig 3: Identifying Joint Support VAS 6131/13-7

Courtesy of AUDI OF AMERICA, LLC

-- Raise engine from engine carrier.

-- Remove the bolts -arrows- and the left engine support.

Fig 4: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- and free up the ground wire at the engine support.

Fig 5: Identifying Bolts & Right Engine Support

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the right engine support.

-- Secure the starter on the engine.

-- Secure the engine with Engine/Transmission Holder - Universal Mounting VAS6095/1 and Engine/Transmission Holder - V6 FSI Bracket VAS6095/1-5 on the Engine And Transmission Holder VAS6095 to 40 Nm as shown in the illustration.

Fig 6: Identifying Engine, Holder VAS 6095 And Bracket For V6 FSI Engine VAS 6095/1-5

Courtesy of AUDI OF AMERICA, LLC