Overview - Piston And Connecting Rod

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Lubricate all bearings and running surfaces.

Oil injector jet for piston cooling, refer to Fig 5.

Fig 1: Identifying Pistons And Connecting Rod Overview

Courtesy of AUDI OF AMERICA, LLC

Bolts
- 50 Nm +90°
- Replace
- Use old bolts to measure radial play.
- Lubricate the thread and contact surface.
Connecting Rod Bearing Cap
- Mark for installation later
- Mark affiliation to cylinder with paint, refer to Fig 3
- Installation position of connecting rod pairs, refer to Fig 4
Bearing Shells
- Make sure the tabs are tight
- Replace any worn bearing shells
- Oversized bearings are available for reworked crankshaft connecting rod journals .
- The connecting rod tabs are above each other
Connecting Rod
- Always replace as a set.
- Mark affiliation to cylinder with paint, refer to Fig 3
- Installation position of connecting rod pairs, refer to Fig 4
- Axial play for each new connecting rod pair: 0.20 to 0.45 mm
- Radial play, measuring, refer to CONNECTING RODS, CHECKING RADIAL CLEARANCE .
Circlip
- Replace
Piston Pin
- Removing and installing, refer to PISTONS, REMOVING AND INSTALLING .
Piston
- Mark the installation position and cylinder allocation, refer to Fig 2
- Replace the piston if there are cracks on the piston head or piston shaft
- Removing and installing, refer to PISTONS, REMOVING AND INSTALLING .
- Checking, refer to Figure.
- Install with piston ring compressor
- Piston and Cylinder Dimensions, refer to PISTONS AND CYLINDER BORE, CHECKING .
- Measuring cylinder bore, refer to Figure
Piston Rings
- Measuring the gap, refer to Figure
- Measuring side clearance, refer to Figure
- Use piston ring pliers for removing and installing
- Installed position: "TOP" marking or side with writing faces the piston crown.
- Offset gaps by 120°

Fig 2: Identifying Installed Position Of Piston And Piston/Cylinder Allocation

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The coating on the piston crown could be destroyed.

Mark the allocation to the cylinder on the piston crown with paint to install used pistons. Do not mark the piston head with a punch, notch or something similar.

Installed position:

The arrows on the piston heads point to the belt pulley side.

NOTE:

Only replace connecting rod as a set.

-- Mark the connecting rod and connector rod bearing caps to each other and to the cylinder -arrow- with paint for installation.

Fig 3: Marking Connecting Rod With Paint For Installation

Courtesy of AUDI OF AMERICA, LLC

The molded tabs -arrows- at the beveled surfaces of the connecting rod pairs must point toward each other.

Fig 4: Connecting Rod Molded Tabs Installed Location

Courtesy of AUDI OF AMERICA, LLC

Fig 5: Oil Spray Jet For Piston Cooling

Courtesy of AUDI OF AMERICA, LLC

Insert the bolt with locking compound and tighten to 9 Nm. Allocate correct locking compound.
Oil spray jet with spray nozzle valve (opening pressure 2 to 2.4 bar (29 to 34.8 psi))

CAUTION:

The oil spray jets could get damaged.

Do not bend the oil injector jets.
Bent oil injector jets must be replaced.