Overview - Radiator/Front Charge Air Cooling Circuit Radiator
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator, refer to Fig 2
- O-Ring
- Replace
- Air Guide
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator, refer to Fig 2
- O-Ring
- Replace
- Radiator
- Removing and installing with the fan shroud, refer to RADIATOR, REMOVING AND INSTALLING .
- After replacing, replace all the coolant.
- O-Ring
- Replace
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator, refer to Fig 2
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator, refer to Fig 2
- O-Ring
- Replace
- Air Guide
- Coolant Hoses
- Bolt
- 4.5 Nm
- Front Charge Air Cooling Circuit Radiator
- Removing and installing, refer to FRONT RADIATOR CHARGE AIR COOLING CIRCUIT, REMOVING .
- Retaining Pin
- Disengage and remove using screwdriver
- Rubber Bushing
- For the radiator
- Rubber Bushing
- For the radiator
- Radiator Bracket
- There are different versions. For the correct allocation, refer to parts.
- Bolt
- 5 Nm
- Backing Plate
- Bolt
- 4.5 Nm
-- Remove the old O-ring -2- in the coolant hose -3-.
-- Coat the new O-ring with coolant and install it in the coolant hose.
-- Press the coolant hose onto the connection -1- until it engages audibly.
-- Press the coolant hose on again and pull to make sure the connection is engaged correctly.