Left Charge Air Cooling Circuit Radiator, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Wheel Housing Liner

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left front wheel.

-- Remove the left front wheel housing liner -1-, refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

-- Disconnect the connector -5-.

-- Loosen the hose clamps -1 and 3-, then clamp off the coolant hoses with the Hose Clamp - Up to 25mm 3094 and remove them.

-- Free up the coolant hose.

Fig 2: Removing Charge Air Cooling Circuit Cooler From Bracket (1 Of 3)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -2- and the bolt -4-.

-- Remove air duct -1- from the cooler -2- charge air cooling circuit cooler in direction of -arrow- into the installed position.

Fig 3: Removing Charge Air Cooling Circuit Cooler From Bracket (2 Of 3)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the charge air cooling circuit cooler with the Charge Air Cooling Pump -V188-.

-- Loosen the clamp -2- and remove the coolant hose.

-- Remove the bolts -arrows-.

-- Remove charge air cooling circuit cooler -1- from the bracket -3-.

Fig 4: Removing Charge Air Cooling Circuit Cooler From Bracket (3 Of 3)

Courtesy of AUDI OF AMERICA, LLC