Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is cold.
-- Quickly open the coolant reservoir cap and release any remaining pressure in the cooling system and then close it again.
-- Remove the front engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Disconnect the connector -1-.
NOTE:
Use a cloth to catch any leaking coolant.
Ignore -arrow-.
-- Remove the retaining clip -2- and the Engine Coolant Temperature Sensor -G62-.