LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 623 (3.0L - Engine Cooling System - Engine Code(S): CTUC & CTUD) >> 19 Cooling System >> Coolant Pump/Thermostat >> Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING >> Installing

Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

To prevent coolant loss, immediately insert new Engine Coolant Temperature Sensor -G62- in the connections.

-- Install the front engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Check the coolant level, refer to CHECK THE COOLANT LEVEL .

scientia non olet · About LEMON Manuals