General Repair Information
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the working area and tools before working on the injection system.
- If the high pressure lines will not be replaced, mark them when removing. The high pressure lines must be installed again in the same cylinder.
- Align the high pressure lines free of tension. First tighten all connections hand-tight and then tighten them again to the tightening specification.
- Never bend the high pressure lines.
- It is permitted to use tools only for tightening and loosening the lines on the entire high pressure system. All other installation or removal procedures must be performed by hand without using any tools.
- All cable ties which are opened or cut open when removing, must be replaced in the same position when installing.
- Fuel hoses in engine compartment must only be secured with spring-type clips. The use of clamp or screw type clips is not permissible.