LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 615 (Exterior Equipment) >> 66 Exterior Equipment >> Name Badges And Emblems >> Name Badges, Removing And Installing

Name Badges, Removing And Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

CAUTION:
  • Badges and emblems that are remove must be replaced.
  • The vehicle must reach room temperature before installing the name badge and emblems.
  • The adhesive surface on the body must be free of dirt and grease, as well as free of adhesive residue.
  • Clean the adhesive surfaces using Cleaning Solution D 009 401 04.
  • Warm the adhesive surfaces to approximately 40 °C (104 °F) using a hot air blower.
  • After installing, take the roller and press the brand emblems one more time.
scientia non olet · About LEMON Manuals