Wheel Cover, Version 2, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- The fender must be free of dirt and grease in the adhesive area.
-- Warm the area where the adhesive will be applied to approximately 40 °C (104 °F) with a hot air blower.
-- Remove the peel-off backing -3- from the tape.
-- Place the cover -2- on the fender. Install the tab -4- behind the fender, as illustrated.
-- Press the cover firmly and evenly over the entire surface with the Roller 3356.
-- Secure the cover with the clips -1-.