Passenger Occupant Detection System, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Pry Lever 80 - 200
WARNING:
- Follow all safety precautions when working with pyrotechnic components (refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS ) and on the passenger occupant detection system (refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC ).
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passenger Occupant Detection System Control Module -J706-
- Passenger Occupant Detection System Pressure Sensor -G452-
- Passive Occupant Detection System Mat
- Seat cushion
- Wiring harness between the Passenger Occupant Detection System Control Module -J706- and Passenger Occupant Detection System Pressure Sensor -G452-