Component Location Overview - Passenger Occupant Detection System
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passive Occupant Detection System Control Module -J706
- Passive Occupant Detection System Pressure Sensor -G452
- Passive Occupant Detection System Mat
- Seat cushion
- Wiring harness between the passenger occupant detection system control module -J706 and passenger occupant detection system pressure sensor -G452.
WARNING:
Follow all safety precautions when working on the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION ADDITIONAL SAFETY PRECAUTIONS, MARKET-SPECIFIC .
NOTE:
The passenger occupant detection system is only installed in the front passenger seat.
- Passenger Occupant Detection System Pressure Sensor -G452-
- is part of the seat occupied recognition mat -6-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the electrical connector.
- Lower Seat Frame
- Clip
- Cushion
- For the lower seat frame
- Do not separate from the seat occupied recognition mat -6-
- Clip
- Do not release.
- Mat
- For the passenger occupant detection system
- Is a component of the Passenger Occupant Detection System Pressure Sensor -G452-
- Do not separate from the seat pan upholstery -4-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Mount
- Equipment levels
- For the Passenger Occupant Detection System Control Module -J706-
- Expanding Pin
- For securing the mount to the lower seat frame
- Wiring Harness
- Do not separate from the Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
- Front Passenger Seat Position Sensor -G554-
- Is a component of the electrical wiring harness -9-
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING, WITH SEAT OCCUPIED SENSOR FOR PASSENGER AIRBAG DEACTIVATION .
- Passenger Occupant Detection System Control Module -J706-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the electrical connector.
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm