Driver Side Airbag, Assembly Overview, Attached Airbag Version
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Locking Bracket
- Use a T25 TORX screwdriver, approximately 100 mm long
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138- and Steering Angle Sensor -G85-
- Overview. Refer to STEERING COLUMN ELECTRONICS CONTROL MODULE -J527-, REMOVING AND INSTALLING .
- 4-Spoke Steering Wheel
- Equipment levels
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING, ATTACHED AIRBAG VERSION .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification: 30 Nm +90° , OVERVIEW - STEERING WHEEL (CABRIOLET) / OVERVIEW - STEERING WHEEL (COUPE) .
- 3-Spoke-Steering Wheel
- Equipment levels
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING, ATTACHED AIRBAG VERSION .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification: 30 Nm +90° , OVERVIEW - STEERING WHEEL (CABRIOLET) / OVERVIEW - STEERING WHEEL (COUPE) .